4
Feature Select Programming Method
After entering certain sections, eight options will be displayed. In these instances, each option (from 1 to 8) represent a specific
feature. To turn enable the option, press the key corresponding to the desired option. Press the key again to remove the digit,
thereby, disabling the option. Press
SLEEP to disable all eight options. When the options are set, press ENTER to save your settings
and advance to the next section.
Viewing Version Numbers
Decimal and Hexadecimal Programming
Table 2: Decimal and hexadecimal values for 10 and 32-Zone LED keypads
Value or Action Key
Result
32-Zone LED 10-Zone LED
Value 0/replace current
digit with 0
SLEEP Erase digit and remain in section Erase digit and remain in section
Values 1 to 9 1 to 9 Zone 1 to 9 Keys 1 to 9
A (hex only) 0 Zone 10 Key 0 (10)
B (hex only)
OFF Zone 11 OFF
C (hex only) BYP Zone 12 BYP
D (hex only) MEM Zone 13 MEM
E (hex only) TBL Zone 14 TBL
F (hex only) Zone 15
Exit without saving
CLEAR Arm and Stay LEDs flash Arm and Stay LEDs flash
Save data (hex only)
ENTER Advances to next section Advances to next section
Example: Version 01.42
NOTE: For keypads K10V/H and K636, the keypad version numbers cannot be viewed.
Table 1: Viewing panel and keypad version numbers
Step Action Details When Viewing Keypad Version
1
Enter viewing mode:
• For panel version, enter section [980]
•For keypad version, enter installer programming,
then press and hold
ARM
The first digit is displayed
(usually 0)
Digit 1: ARM is illuminated
2Press
ENTER The second digit is displayed Digit 2: SLEEP is illuminated
3Press
ENTER The third digit is displayed Digit 3: STAY is illuminated
4Press
ENTER The fourth digit is displayed Digit 4: OFF is illuminated
Digits 1-4
To Next Page
Loading...
Need help?
General
