Paradox SP5500+ User Manual

62
SP+ Series Programming Guide
Appendix A
EN 50131 Programming
The following sections describe all the programming required for your panel to be EN 50131 compliant.
To set your panel to be EN 50131 compliant:
1. Enter section [951] to unlock the software and set EN 50131 defaults.
2. Press Enter.
NOTE: All keypads in the system must have anti-tamper enabled in order to be EN 50131 compliant.
EN 50131 Standard System Defaults
The following sections are provide the system defaults that will be set for EN50131 compliancy. The following provides information on sections [700] through
[840].
ATZ, Zone Tamper and Supervision Options
Table 53: Description of section [700]
Section Option Option Type Description OFF ON
Section [700]
1 Partitioning Partitioning  Disabled

Enabled
2
General system options
Battery charging  350mA

700mA
3 Audible trouble warning (except AC failure)  Disabled

Enabled
4 Audible trouble warning on AC failure  Disabled

Enabled
5 RF jamming supervision RF jamming supervision

Disabled  Enabled
6
General system options
Exit delay termination  Disabled

Enabled
7 Tamper supervision on the bus module

Disabled  Enabled
8 Panel Tamper Panel Tamper Supervision

Disabled  Enabled
Table 54: Description of section [703]
Section Option Option Type Description OFF ON
Section [703]
1
Keypad options 2
One-touch regular arming (also REM3)  Disabled

Enabled
2 One-touch stay arming (also REM3)  Disabled

Enabled
3 One-touch sleep arming (also REM3)  Disabled

Enabled
4 One-touch bypass programming  Disabled

Enabled
5
Arming/disarming options
Restrict arming on battery failure

Disabled

Enabled
6
Restrict arming on tamper failure (zone + bus
module + wireless PGM)

Disabled

Enabled
7
Restrict arming on supervision trouble;
wireless zones & PGM + bus module

Disabled

Enabled
8 Future Use - - - - -
Table 55: Description of section [705]
Option Description OFF ON
Section [705]
1 ATZ zone doubling  Disabled

Enabled
2ATZ wiring options  Series

Parallel
3
Tamper recognition (see following table)

Disabled  Enabled
4  Disabled

Enabled
5 Generate tamper on bypassed zone

No  Ye s
6
Supervision options (see following table)

Disabled  Enabled
7  Disabled

Enabled
8 Generate supervision on bypassed zone

No  Ye s
= Default

Paradox SP5500+ Specifications

General

StayD Mode	Yes
PGMs	4 programmable outputs
Partitions	2 partitions
Expandable via Bus	Yes
Outputs	4 programmable outputs
Power Supply	1.5A
Battery Backup	7Ah