Paradox SPECTRA SP5500

18 Programming Guide
Event Description
Event Group # Sub-group #
00 = Zone OK
01 to 32 = Zone number
99 = Any zone number
01 = Zone open
02 = Partition status 00 to 01= N/A
02 = Silent alarm
03 = Buzzer alarm
04 = Steady alarm
05 = Pulsed alarm
06 = Strobe
07 = Alarm stopped
08 = Squawk ON (Partition 1 only)
09 = Squawk OFF (Partition 1 only)
10 = Ground start (Partition 1 only)
11 = Disarm partition
12 = Arm partition
13 = Entry delay started
14 = Exit delay started
15 = Pre-alarm delay
99 = Any partition status event
03 = Bell status (Partition 1 only) 00 = Bell OFF
01 = Bell ON
02 = Bell squawk arm
03 = Bell squawk disarm
99 = Any bell status event
06 = Non-reportable event 00 = Telephone line trouble
01 = [
ENTER] / [CLEAR] / [ ] key was pressed (Partition 1 only)
02 = N/A
03 = Arm in stay mode
04 = Arm in sleep mode
05 = Arm in force mode
06 = Full arm when armed in stay mode
07 = PC fail to communicate (Partition 1 only)
08 = Utility Key 1 pressed (keys [1] and [2]) (Partition 1 only)
09 = Utility Key 2 pressed (keys [2] and [3]) (Partition 1 only)
10 = Utility Key 3 pressed (keys [4] and [5]) (Partition 1 only)
11 = Utility Key 4 pressed (keys [5] and [6]) (Partition 1 only)
12 = Utility Key 5 pressed (keys [7] and [8]) (Partition 1 only)
13 = Utility Key 6 pressed (keys [8] and [9]) (Partition 1 only)
14 = Tamper generated alarm
15 = Supervision loss generated alarm
16 = N/A
17 = N/A
18 = N/A
19 = N/A
20 = Full arm when armed in sleep mode
21 = Firmware upgrade (Partition 1 only)
99 = Any non-reportable event
07 = Remote control access 01 to 32 = Remote control number
99 = Any remote control number
08 = Button pressed on remote
(See button option “B” on page 26)
09 = Button pressed on remote
(See button option “C” on page 26)
10 = Button pressed on remote
(See button option “D” on page 26)
11 = Button pressed on remote
(See button option “E” on page 26)
12 = Cold start wireless zone 01 to 32 = Zone number
99 = Any zone number