Parker 890SD - SD Frame F Power Connections

Page 12
890SD Frame F Power Connections
 Connect motor leads to M1/U, M2/V, M3/W.
Maximum wire sizes::
Frame F: 95mm
2
/ 4/0AWG (without crimp)
95mm
2
/ 4/0AWG (with crimp)
 Connect the earth/ground wire from the terminal
box of the motor directly to the earth/ground
terminal.
Maximum wire sizes:
Frame F: 95mm
2
/ 4/0AWG (without crimp)
95mm
2
/ 4/0AWG (with crimp)
 If not using shielded cable, run motor leads in an
enclosed metal conduit bonded to the drive at
one end and the motor at the other.
 Connect the earth/ground wire to the
earth/ground terminal.
Maximum wire sizes:
Frame F: 95mm
2
/ 4/0AWG (without crimp)
95mm
2
/ 4/0AWG (with crimp)
5
 Connect the 3-phase supply.
Maximum wire sizes:
Frame F: 95mm
2
/ 4/0AWG (without crimp)
95mm
2
/ 4/0AWG (with crimp)
6
7
Connect the 115 or 220Vac auxiliary
supply for the internal fans to AUX 1 and
AUX 2 (in any order).
See block 5 of the Model Number:
1F = 115Vac, 2F = 220Vac.
8
 Connect the brake resistor.
Maximum wire sizes:
Frame F: 95mm
2
/ 4/0AWG (without crimp)
95mm
2
/ 4/0AWG (with crimp)
 An External Braking Resistor is optional.
Connect it between DBR+ and DBR- for
high inertial loads.
DO NOT apply external voltage sources
(mains supply or otherwise) to the braking
terminals.
We recommend using a thermal overload
switch to protect the braking circuit.
9
5
6
5
6
7
Bond the motor cable
screen to the drive and
motor, as close as
possible to both terminals
PE1
Terminate all
control cable screens
using a gland at the
gland plate
auxiliary
supply
terminals
(fan)
M1/U M2/V M3/W
3-Phase Supply
Motor
8
L1 L2 L3
9
brake
resistor
terminals