Parker 890SD - Appendix A: Using the 6901 Keypad

Page 18
Appendix A: Using the 6901 Keypad
The 6901 keypad has a two-line backlit LCD display with units and
symbols. It can be used to setup and configure the 890 in plain
language. It can also be used to operate the drive in Local mode
from its Start and Stop buttons, Jog and reverse.
Menus :
exit a menu
sub-menu or
parameter
scroll up
scroll down
Parameters :
exit
parameter
make writable
previous
parameter
next
parameter
Edit
stop editing
show PREF
(hold)
increment
value
decrement
value
To change Operating Mode:
From power-up, the keypad displays the Software Version, and then times-out to show the Remote
Setpoint.
Mode
Action
Remote to Local
Toggle between modes using the L/R key
SEQ and REF LEDs are On when in Local
Local to Remote
Toggle between modes using the L/R key
SEQ and REF LEDs are Off when in Remote
SEQ and REF LEDs are On
when in Local mode
To display the Software Version and
Voltage Rating:
Press repeatedly to display the
Welcome Screen
Press to return to the Menus
To Stop in
Local Mode:
Press
To Start in
Local Mode:
Press