Parker Hannifin
The description and parameter numbers are shown in the following table.
The control parameters are those that should be set before attempting to
start the network. The status parameters are those that the controller will set
because of attempting to start the network.
Extended I/O Control/Status
Control Parameters
Master node ID P32768
Bit Rate (Kb) P32769
Number of slave nodes P32770
Alt Digital I/O Mapping P32771
Cyclic Period (milliseconds) P32772
Status Parameters
Health Period (milliseconds) P32773
Reserved P32774
Number of digital inputs bytes P32775
Number of digital outputs bytes P32776
Number of analog inputs P32777
Number of analog outputs P32778
Bus state (see table below) P32779
Reserved P32782
Reserved P32783
134 ACR9000 Series Hardware Installation Guide
www.comoso.com
To Next Page
Loading...
Need help?
General
