Parker ET Series - Assembly Information

Parker Hannifin Corporation
Automation Actuator Division
Wadsworth, OH 44281
17
Automation
ET Series
PM-ET01/USA Stepper and Servo Driven Linear Actuators
Assembly Information
NOTE: Use appropriate personal protection equipment when using adhesives (refer to applicable MSDS).
Part Description Lubricant/Adhesive
Cylinder rod-end - Female Loctite 271
Flat Head Cap Screw Loctite 242
Set screw Loctite 242
Cylinder rod-end - Male Loctite 271
Tie rod bolt and tie rod nut Loctite 271
Apply between the tie rod
bolt and nut only.
Screw support bearing Grease
If not sealed
The following parts, when assembled, require the use of industrial lubricants or adhesives as indicated.