Parker Hannifin Corporation
Automation Actuator Division
Wadsworth, Ohio
28
Automation
Stepper and Servo Driven Linear ActuatorsPM-ET01/USA
ET Series
MODELS SMR-1L, SMD-1L LOW AMP REED SWITCH SPECIFICATIONS
Switching Logic: Normally Open (SMR-1 L)
Normally Closed (SMD-1 L)
Voltage Rating: 85-125 VAC (N.O.)
5-24 VAC (N.C.)
5-24
VDC
* (N.O.)
5-24
VDC
* (N.C.)
Power Rating:
AC or DC Resistive Load: 10 watts (N.O.)
AC or DC Inductive Load: 5 watts (N.O.)
AC or DC: 3 watts (N.C.)
Switching Current Range:
Resistive Load (PC, Sequencer): 5-40 mA (N.O.),
5-25 mA (N.C.)
Inductive Load (Relay): 5-25 mA
Minimum Current for LED: 5mA
Switching Response: 300 Hz (N.O.), 200 Hz (N.C.)
Breakdown Voltage: 200VDC
Contact Resistance: 100M Ohm minimum.
Operating Temperature: -10
° to 85°C (14° to 185°)**
Lead Termination: 1500 mm (60 In) or 150 mm (6 in) with connector
Industrial Protection: IP67
Shock Resistance: 30 g’s, 300 m/sec
2
*Polarity restriction for DC operation: (+) to brown
and
(-) to blue.
**Exceeds temperature range for ET series mechanical components
NOTE: Use care not to exceed the switch’s power rating while operating within the switch’s voltage and current limits.
MODELS SMR-1 HIGH AMP SWITCH SPECIFICATIONS
Switching Logic: Normally Open
Voltage Rating: 85-125 VAC
5-24
VDC
*
Power Rating:
AC or DC Resistive Load: 10 watts
AC or DC Inductive Load: 5 watts
Switching Current Range:
Resistive Load (PC, Sequencer): 30-300 mA
Inductive Load (Relay): 30-100 mA
Minimum Current for LED: 18 mA
Switching Response: 300 Hz
Breakdown Voltage: 200VDC
Contact Resistance: 100M Ohm minimum
Operating Temperature: -10
° to 85°C (14° to 185°)**
Lead Termination: 1500 mm (60 in.) or 150 mm (6 in.) with connector
Industrial Protection: IP67
Reed Switch Specifications
Shock Resistance: 30 g’s, 300 m/sec
2
*Polarity restriction for DC operation: (+) to brown
and
(-) to blue.
**Exceeds temperature range for ET series mechanical components
To Next Page
Loading...
