Parker GVM Series - GVM Motor Cooling System Requirements

- 56 –
18-06-08 PVD3668_GB_GVM_June_2018
3.6. Cooling
3.6.1. General recommendations
Danger: It is compulsory to start the cooling system before starting the
motor.
Danger: The Inlet temperature and the water flow have to be monitored
to avoid any damage.
Caution: When motor is no more running, the cooling system has to be
stopped 10 minutes after the motor shut down.
Danger: If the water flow stops, the motor can be damaged or destroyed
causing accidents.
Danger: For the oil cooling system, a pre-heating at 40°C is
recommended before starting the motor.