Parker HAS Series - Page 83

Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois
www.parker.com/cylinder
Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
Catalog HY08-4005-M3
84
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Diagnostic Menu
DDIIAAGGNNOOSSTTIICC MMEENNUU
PPRREEFF 66551111 DDiissppllaayy 66990011 DDiissppllaayy
99.06 BBRRAAKKIINNGG
RRaannggee:: FALSE / TRUE
A read-only parameter indicating the state of the dynamic brake switch.
(Refer to the DYNAMIC BRAKING function block)
73.04 DDRRIIVVEE FFRREEQQUUEENNCCYY
RRaannggee:: —.xx Hz
The drive output frequency in Hertz.
(Refer to the PATTERN GEN function block)
97.05 AACCTTIIVVEE WWOORRDD 11
RRaannggee:: 0000 to FFFF
Indicates which trips are currently active. These parameters are a coded representation of the trip status.
(Refer to the TRIPS STATUS function block)
97.06 AACCTTIIVVEE WWOORRDD 22
RRaannggee:: 0000 to FFFF
Indicates which trips are currently active. These parameters are a coded representation of the trip status.
(Refer to the TRIPS STATUS function block)
97.09 FFIIRRSSTT TTRRIIPP
RRaannggee:: Enumerated - refer to block
From when a trip occurs until that trip is reset, this parameter indicates the trip source. When
several trips have occurred, this parameter indicates the first one that was detected.
(Refer to the TRIPS STATUS function block)
87
wwwwww..ppaarrkkeerr..ccoomm/
cylinder