65
2.6 Residual energy
Please ensure that different residual energies can still be present when the machine is
shut down or idle – for example:
• In hydraulic pressure lines and pressure tanks
• In live power lines and capacitors
2.7 Structural changes to the device
• No changes, additions or conversions may be made to the device without the
manufacturer’s approval.
• Replace any device parts immediately that are not in perfect condition or contact the
manufacturer for this.
• Only use original spare parts.
2.8 Cleaning (and disposing of) the device
Cleaning:
- always disconnect the power plug prior to cleaning
- only use alkaline-based cleaning agents
Disposal:
- The required qualifications must be observed for dismantling and disposal
(see table in section 16).
2.9 Accident prevention regulations, occupational safety guidelines
The relevant accident prevention regulations and occupational safety guidelines must be
complied with by the operator as mandatory.
Switch off the device immediately in the event of an accident.
To Next Page
Loading...
