Parker Parflange 1025 - Page 86

79
13.2 Triple-Lok
®
assembly instructions
37° flaring
Parflange® process
•
Safe and efficient method
•
Use the Parflange
®
process
Parflange
®
1025
• Select flaring pin in
accordance with tube
dimensions
• Use the special “SS” pin
for stainless steel tubing
• The flaring pin must not
feature any wear and
tear, damage or
contaminants
• Insert flaring pin in tool
holder
• Keep the flaring pin clean
and lubricate it regularly
• Select the clamping
jaws in accordance
with the tube
dimensions
• Use the special “SS”
clamping jaw for stainless
steel tubes
• The clamping surfaces
must not feature any wear
and tear or abrasion
• Only use original Parker
tools for Triple-Lok®
• Insert flaring pin in tool
holder
• Ensure that the automatic
lubricating unit is filled with
EONIROMONTFLUESSX
or LUBSS
• Insert the closed jaw set
into the conical tool holder
• Keep the sliding surfaces
clean and lubricated
• Ensure that the automatic
lubricating unit is filled with
EONIROMONTFLUESSX
or LUBSS
Insert tube end until the
stop point
• Close the clamping
lever
• Secure the tube
Do not reach into the
operating area
• Open the clamping
lever
• Remove tube end
from the machine
with clamping jaws
• Loosen the jaws in
the separator by
moving the tube
sideways
• Slide the nut and support
sleeve over the tube end
See CAT 4100 at www.parker.com on
the checks of the dimensions
See CAT 4100 at
www.parker.com on
the checking instructions and tool
settings