Parker PSD1-S - Front View (PSD1-M)

192-011003N7_PSD1-M_Short_Description
192-011003N7 DOC-0001-01-B 11.12.23 11:39 15 (31)
4.1 Front view (PSD1-M)
CAUTION: Risk of electric shock
Caution - Risk of electric shock!
Before wiring or loosening electrical connections please observe the
following:
• Risk of electric shock, disconnect power before removing cover resp. disconnect the
devices from the mains supply.
•
Caution! Dangerous electrical voltage even after turning off the intermediate
capacitors:
Up to 10 minutesafter switching off mains supply, dangerous voltages may
still be present.
Please check that no voltages are present (<50 V) at the output terminals DC+ and DC-
(X63/4 & X63/5).
View from above (see page 18)
P10
Status of LEDs for the fieldbus
C11
Slot for SD card
(SD card not included in delivery)
X30 (see page 19)
Digital Inputs / Outputs IO Optionboard2
X31 (see page 19)
Analogue Inputs and Encoderinput IO
Optionboard2
S12
Device address higher value half-byte
(accept with power ON)
S13
Device address low value half-byte (accept
with power ON)
P14
Status LED axis 1
P15
Status LED axis 2
P16
Status LED axis 3
X17
Digital inputs/outputs axis 1 & 3
X18 *
Feedback sensor Axis 1: Resolver,
Encoder/Hall
X19 *
Feedback sensor Axis 2: Resolver,
Encoder/Hall
X20 *
Feedback sensor Axis 3: Resolver,
Encoder/Hall
S33
For security option
S34
For security option
X37 (see page 19)
Digital Inputs / Outputs IO Optionboard1
X38 (see page 19)
Analogue Inputs and Encoderinput IO
Optionboard1
X21
Digital inputs/outputs axis 2 & 3
24 VDC & DC Power
Behind the yellow protective covers you
can find the rails for the supply voltage
connection to the mains module
PSD1-M_P.
• 24 VDC power supply
•
DC power voltage supply
View from below (see page Fehler! Textmarke nicht definiert.)
*
Before connecting a feedback cable, check that the correct feedback system is
configured in the device.
Otherwise, destruction of the feedback system is threatened by overvoltage!