Page 6 – SD-453
Click here
This should
be at 100
Figure J - Override solenoid in a circuit
(See Step 5)
Figure K - Changing status of Solenoid in a circuit
(See Step 5)
Figure L - Parameters screen with
overrides highlighted in yellow
(See Step 5)
Click here
Figure M - Override EEPR to 100% open
(See Step 5)
Make sure this switch
is on CLOSED
This will likely already say
CLOSED as it does here
Click SAVE after switch is
set to CLOSED
Click SAVE after switch is
set to 100%
To Next Page
Loading...
