8
Installation
Installation
Safety instructions
Note: We advise our customers to have the Parrot ASTEROID Smart installed by a Parrot
certified installer.
Turn the ignition off before installing the Parrot ASTEROID Smart.
Do not install the Parrot ASTEROID Smart where it may interfere with the driver
operation of the vehicle.
Do not drill holes in the dashboard or any panel without first making sure there is
nothing behind it. Do not damage any fuel line, electronic component or cable.
If you need to use screws, do not allow them to come into contact with any power
cable.
Install the Parrot ASTEROID Smart only on vehicles with a 12 V battery. If your vehicle
(e.g. : truck) has a 24V battery, the use of a step-down converter is essential.
Place all cables away from hot places (heater outlet) and moving parts (gear shift, seat
rails...). Make sure they will never wind around the steering column or gearstick.
Confirm the proper function of your vehicle's other equipment after installing the
Parrot ASTEROID Smart.
Do not install the Parrot ASTEROID Smart or one of its components where the airbag
may deploy.
Do not install the Parrot ASTEROID Smart in places subject to high temperatures or
humidity.
Make sure you leave enough space behind the Parrot ASTEROID Smart once installed
so that proper heat dispersal is ensured.
Before you begin
Remove your car stereo from your vehicle. You may need release keys to do so.
Try to connect the audio and power connectors of the Parrot ASTEROID Smart to the
connectors of your vehicle. If this connection is impossible, you have to obtain an ISO
To Next Page
Loading...
Need help?
General
