100
If the hydraulic warping device is installed on the outboard motor and exhausting is
required, please follow the following steps.
1. Turn the manual valve counterclockwise until it cannot turn.
1. Manual valve.
2. Tilt the outboard motor completely upward, and then lower it downward by its own
gravity; Repeat 4~5 times.
3. Turn the manual valve clockwise until it cannot turn.
4. Wait for 5 minutes to stabilize the oil.
5. Press and hold the warping switch until the outboard motor is completely warped.
6. Wait for 5 minutes to stabilize the oil.
7. Remove the oil drain screw and observe the oil level.
8. If necessary, repeat the above steps until the oil level is correct.
9. Install the oil drain screw and tighten it.
Specified torque: 6.5 Nm
To Next Page
Loading...
Need help?
General
