Partlow MIC 6000 - Profile Continue Mode

PAGE 40
TABLE 4-1 PROFILE CONTINUE MODE - Not available when Ptb=4, 5, or 6
(EO Option only)
DISPLAY
STEP DESCRIPTION CODE ACTION
1 Profile Number Pn Press the SCROLL key to see the
number of the last active profile.
2 Profile Number Value X If necessary, use the UP or DOWN key
to change the profile number to the
desired value, then press the SCROLL
key.
3 Segment Number Sn Press the SCROLL key to see the
number of the last active segment.
4 Segment Number Value X If necessary, use the Up or Down key
to change the segment number to the
desired value, then press the SCROLL
key. DO NOT SET THIS VALUE TO 0
AND ATTEMPT TO RUN THE
PROFILE. AN ERROR 19 WILL
DISPLAY AND THE PROFILE WILL
NOT RUN.
5 Ramp Time Remaining rtr Press the SCROLL key to see the
Ramp Time Remaining value.
6 Ramp Time Remaining X If necessary, use the UP or DOWN key
Value to adjust the Ramp Time Remaining
value, then press the SCROLL key. If
the time remaining is set to 0 when the
SCROLL key is pressed, the Soak Time
Remaining code will be displayed. If
the time remaining is greater than 0,
then the display will advance to the
Profile Loop Count code.
7 Soak Time Remaining Str Press the SCROLL key to see the Soak
Time Remaining value of the last active
profile.
8 Soak Time Remaining X If necessary, use the UP or DOWN key
Value to adjust the Soak Time Remaining
value, then press the SCROLL key.
9 Event(s) E1-E3 If any event outputs have been selected
in the Program mode then each event
number selected will be displayed in
sequence. Press the SCROLL key to
see the status of the event(s).
10 Event(s) Status on/oFF If necessary, use the UP key to turn on
an event that is off or the DOWN key to
turn off an event that is on. Press the
SCROLL key to see the next event
number. After the last event status is
selected, pressing the SCROLL key
will advance the display to be PLCt.