*** On-Chip Serial ATA Setting ***
The following items allow you to congure the settings about On-Chip Serial ATA.
SATA Mode
This feature allows users to select SATA mode.
On-Chip Serial ATA
This feature allows users to select the SATA function modes. Setting at Disabled will disable SATA controller.
Set at Auto will allow the BIOS to arrange it. Setting Combined Mode will make PATA and SATA combined.
Max. of 2 IDE drives in each channel (primary master/slave; secondary master/slave). Enhanced Mode allows
max. of 6 IDE drives supported. SATA Only will make SATA operates in legacy mode.
PATA IDE Mode
This option determines whether the IDE devices are considered the primary or secondary ports on the system.
SATA Port
This option controls the operation speed of the SATA 2 ports, allowing for either legacy SATA-150 operation
or full speed SATA 2 operation. Note that this setting is enabled only while the On-Chip Serial ATA option is
set to Enhanced Mode.
To Next Page
Loading...
