Partner PT-6212 - Figure 2.11 Superio Device Submenu; Superio Device

20 CHAPTER 2 BIOS SETUP
► SuperIO Device
Use this item to change settings for I/O devices. Select the item and press <Enter> to open the following
menu:
Onboard Serial Port 1/2
These items are used to assign the I/O address and IRQ for the onboard serial port 1/2. The default setting is
(3F8/IRQ4) / (2F8/IRQ3).
SuperIO Device Figure 2.11
submenu
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Device
Onboard Serial Port 1 [3F8/IRQ4]
Onboard Serial Port 2 [2F8/IRQ3]
Item Help
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults