PAX S300 Manual

8 | P a g e
TCP/IP connection and 9-pin serial connection with C2G Serial to USB adapter
1. Locate the Cables to Go serial
to USB adapter; Model:
26886; UPC-A: 757120268864.
2. Connect the 9-pin adapter to
the 9-hole adapter on the
Serial cable.
3. This is what your set up should
look like when everything is
properly connected.
Make sure to install the
PL2303 Prolific Driver prior to
connecting the USB interface
to the PC.

PAX S300 Specifications

General

Processor	32-bit ARM11
Security	PCI PTS 3.x approved
Card Readers	Magnetic Stripe, Contactless
Connectivity	RS232, USB, Ethernet
Memory	128MB Flash, 64MB SDRAM