Payne PH1Z024 - Page 5

1176
[463]
352.5
EIS.B8]
138.3
DIMENSIONS IN E] ARE IN INCHES
_352.8
[1389]
_3527
[1389]
_537
[211]
0 o
REAR VIEW
706
[27 80]
r
889
[356]
12950
[5098]
BOTTOMOF UNIT
EVAP
COND
i
\\X
LEFT SIDE VIEW
867.0
[B4.13]
8125
[BI99]
BOTTOMOF UNIT
REQUIRED CLEARANCE TO COMBUSTIBLE MATL.
INCHES [mml
TOP OF UNIT ......................................................................................... 0
DUCT SIDE OF UNIT ............................................................................ 0
SIDE OPPOSITE DUCTS ...................................................................... 0
BOTTOM OF UNIT ................................................................................. 0
NEC. REQUIRED CLEARANCES,
INCHES [mm}
BETWEEN UNITS. POWER ENTRY SIDE .................................... 4200 [1066.8]
UNIT AND UNGROUNDED SURFACES. POWER ENTRY SIDE 3000 [914 O]
UNIT AND BLOCK OR CONCRETE W/ALLS AND OTHER
GROUNDED SURFACES, POWER ENTRY SIDE ......................... 4200 [1066 8]
REQUIRED CLEARANCE FOR OPERATION AND SERVICING
INCHES [mm]
CONDENSER COIL ACCESS SIDE .............................................. 3000 [762 0]
POWER ENTRY SIDE .................................................................. 3000 [762 O]
(EXCEPT FOR NEC REQUIREMENTS)
UNIT TOP ...................................................................................... 4800 [1219 2]
SIDE OPPOSITE DUCTS .............................................................. 3000 [76201
LEGEND
NEC - National Electrical Code
NOTES:
I Clearances must be maintained to prevent recirculation of air from outdoor-
fan discharge, with the exception of the condenser coil (3600 in [9140 mm] A
removable fence or barricade requires no clearance
2 Dimensions are in inches Dimensions in [ ] are in millimeters
_BLOWER, CONTROLBOX ANDEVAP. COIL
ACCESSPANEL
COMPRESSOR PANEL_
FIELD NTRY TO
S RTS
\
o
z
/
_ " ? 1 "
FRONT VIEW
44.5
E1.75]
E2161]
DIA. DIA
[O8B]
751.8
E29.60
30.6
EI.2O] 1981
[1961]
26772 I.D x 127 DEEr
[1OS4D] RIGHT SIDE VIEW
UNIT
PNIZ060
ELECTRICAL CHARACTERBSTICS
UNIT WEIGHT
tb kg
CENTER OF GRAVITY IN. (MM)
Y
254
[1OO]
X Z
208/230-1-60,208/230-3-60, 460-3-60 368 167 14.0 (356) 20.0 (508) 16.0 (406)
C00158
Fig. 4--Unit Base Dimensions, PHIZ060
5