mail@tlct.ru
VENTILATION
• Do not expose the product to high temperatures, such as placing it on top of other product that produce heat
or in places exposed to direct sunlight or spot lights.
• The ventilation slots on top of the product must be left uncovered to allow proper airflow into the unit.
• Do not stand the product on soft furnishings or carpets.
• Do not stack electronic equipment on top of the product.
• Do not place the product in a location subject to extreme changes in temperature. The temperature gradient
should be less than 10 degrees C/hour.
• Place the product in a location with adequate ventilation to prevent the build-up of heat inside the product. The
minimum ventilation space around the unit should be 7 cm. The ventilation should not be impeded by covering
the ventilation openings with items, such as newspapers, table cloth, curtains, etc.
POWER SOURCES
• The product is not disconnected from the AC power source (mains) as long as it is connected to the power
outlet
or wall socket, even if the product is turned off.
• If the product will not be used for a long period of time, disconnect it from the AC power outlet or wall socket.
Before Using the Device
Thank you for purchasing the DCH-5200P Professional HDTV IRD and Processor. This User Manual is written for
operators/users of the DCH-5200P to assist in installation and operation. Please read this user manual carefully
before installation and use of the device.
FOR YOUR SAFETY
This equipment is provided with a protective earthing ground incorporated in the power cord. The main plug shall
only be inserted in a socket outlet provided with a protective earth contact. Any interruption of the protective
conductor, inside or outside the device, is likely to make the device dangerous. Do not remove the covers of this
equipment. Hazardous voltages are present within this equipment and may be exposed if the covers are
removed. Only Beijing Jaeger trained and approved service engineers are permitted to service this equipment.
The supplied AC power cable must be used to power the device. If the power cord becomes damaged it must be
replaced. No operator serviceable parts inside. Refer servicing to Beijing Jaeger trained and approved service
engineers. For the correct and safe use of the device, it is essential that both operating and servicing personnel
follow generally accepted safety procedures in addition to the safety precautions specified in this manual.
Whenever it is likely that safety protection is impaired, the device must be made in-operative and secured against
unintended operation. The appropriate servicing authority must be informed. For example, safety is likely to be
impaired if the device fails to perform the intended measurements or shows visible damage.
WARNINGS
• The mounting environment should be relatively dust free, free of excessive vibration and the ambient
temperature between 0C° to 40C°. Relative humidity of 20% to 80% (non-condensed) is recommended.
• Avoid direct contact with water.
• Never place the equipment in direct sunlight.
• The outside of the equipment may be cleaned using a lightly dampened cloth. Do not use any cleaning liquids
containing alcohol, methylated spirit or ammonia etc.
• For continued protection against fire hazard, replace line fused only with same type.
• Air intake for cooling is achieved via holes at the side of the device and the fans inside. The air flow should not
be obstructed. Therefore, the device has to be placed on a flat surface, leaving some space at the sides of the
device.
• When in operation, the internal temperature should not exceed the limit of 70C°.
To Next Page
Loading...