ООО «ТЛК Трейд» | 196158, г.Санкт-Петербург, Пулковское шоссе, д.30, корп.4, оф. 213В (юр.) | ИНН 7810592830 КПП 781001001
р/с 40702810068000007550 | к/с 30101810200000000704 | Филиал ОПЕРУ ОАО Банк ВТБ в Санкт-Петербурге | БИК 044030704
ОКПО 66035862 | ОКАТО 40284565000 | ОГРН 1107847196060 | т.(812)6499888 | http://www.tlct.ru http://www.rftel.ru
mail@tlct.ru
6.1 Firmware Upgrade from USB Key
The firmware is contained in a file named “target.tgz”. Copy this file in a USB key, connect the key to
the USB port of the equipment to be updated. If the equipment can detect the file “target.tgz” in the
USB key, user can see the message “USB Found“ in the System->USB Status menu of LCD screen.
The firmware upgrade will start automatically if the firmware version in the USB key is higher than the
version in the equipment. It is impossible to make firmware downgrade in automatic mode.
If the firmware version in the USB key is equal or lower than the version in the equipment, user can use
the “Force Mode” in the System menu: System -> USB -> Force Upgrade”.
The equipment will reboot automatically when the software upgrade is finished.
After the firmware upgrade, please check the new version from the menu of front panel LCD: System-
>Properties”, or from the web control software.
6.2 Firmware Upgrade by FTP
Connect the equipment to a PC via a cross over CAT-5 (RJ45) LAN cable or a normal cable using IP
switch/hub. Please ensure that the equipment and the PC are in the same local area network before
upgrade.
Turn on the equipment until the booting is completed. Check the IP address from the LCD screen on
front panel, the default IP address is 10.10.70.48. Please make sure that the equipment and your PC
are in the same IP network, refer to Figure 1. Important: DON’T switch off the equipment and your PC
during the software upgrade.
Open the IE browser and type ftp://10.10.70.48 in the address bar and press Enter. If the network
configuration is correct, you can open the FTP folder without any error, as shown below.
Figure 1: IP Connection Diagram
To Next Page
Loading...