P550c Operation Manual
5 System setup
www.pearpoint.com | 120
Email settings
Use this screen to set up a connection to an email server. You will need to do this if you want to send
survey reports by email. You will also need to set up a WiFi connection to the internet; see page 113.
User Email: Enter the email address for the account you want to use when sending emails from the
controller. The controller will use this account to connect to the email server.
Note: You will select the email recipient when you send a survey report.
Password: Enter the password for the account you will use to send emails from the controller.
Username: If required, enter the SMTP Username for the account you want to use when sending emails
from the controller.
Note: Some email services, including Gmail, will use the SMTP Username attribute as the sender's
address instead of the supplied User Email address.
Server: Enter (or select) the email server you want to use.
If the controller detects a recognized email account type (eg, Outlook or Gmail), it automatically
sets the appropriate email server (smtp-mail.outlook.com or smtp.gmail.com).
Port: If using an SMTP connection, you must enter the TCP port for email submission on your SMTP
server. The default is port 587.
Requires secure connection (TLS): By default, the controller always sends emails over a secure
(encrypted) connection ie, over an SMTPS connection. But you can clear this check box if it is acceptable
to send survey reports over an unencrypted connection
To Next Page
Loading...