P550c Operation Manual
8 WinCan PC connections
www.pearpoint.com | 250
11 Select Change adapter settings.
12 Right click the DVC2 Ethernet connection and select Status.
13 Select Details...
14 In Network Connection Details note the IPv4 Address and the Subnet mask.
15 Select Close to return to the Ethernet DVC2 Status and then Close again to return to the Network
Connection page.
16 Right click the DVC2 Ethernet connection and select Properties.
17 Double click Internet Protocol Version 4.
18 Select Use the following IP address.
19 Enter the noted IP address and Subnet mask in the required fields
20 Check that the IPv4 address matches the P550c controller Ethernet IP address except that the last
digit is 1 or 2 higher or lower
21 Check that the Subnet mask is identical to that of the P550c controller
22 Click on OK to leave Internet Protocol Version 4.
23 Select OK again to leave Ethernet DVC2 Properties.
24 Open WinCan VX
To Next Page