P550c Operation Manual
www.pearpoint.com | 9
Electrical precautions (continued)
The external connectors of the P550c Manual PSU unit and Powered Drum are required to be
properly sealed by the blanking caps provided or by using the correct leads to prevent water damage
to the units. Under no circumstances are these connectors to be left un-blanked.
Take care to ensure that video and power cables do not get entangled in the drum. Cable ties are
recommended and will not impede system performance. Always store the flexitrax P550c system in a
clean and dry environment.
If using a generator follow the manufacturer’s instructions on load connection and sequencing. In the
absence of these instructions the following guidelines should be used:
When starting the generator; ensure that all electrical loads, including the flexitrax P550c are switched
off before starting the generator. Allow the generator to stabilize before connecting any electrical loads
or switching on the flexitrax P550c.
When stopping the generator; ensure all electrical loads, including the flexitrax P550c are switched off
before stopping the generator.
Starting or stopping a generator whilst the flexitrax P550c system is connected and the main switch is in
the On position could lead to damage to the flexitrax P550c system or the generator.
To Next Page
Loading...