PEDROLLO E2 TRI - Configuring Automatic Operation; Configuring Manual Operation

52
| ENGLISH

SELECT
ENABLE WIFI
Congure Wi-Fi connection
9
ENABLE WIFI
ENABLE:NO

SELECT
RESTORE DEF
Reset to factory settings
9
RESTORE DEF
CONFIRM?
When the control panel is powered up, it enters an initial STARTING phase, after which it automatically enters OPER-
ATION mode or goes out of service (OFF), depending on its state when it was last switched o.

SETTING THE LANGUAGE
This menu is used to set the control panel interface language
• Open the menu
SELECT
LANG.CONFIG
• the
key to conrm the choice and enter the submenu
SELECT
LANGUAGE:ENG
• Press the
key to set the language
• Press the
or key and select the desired language (ITA-ENG-DEU-ESP-FRA)
• Press the
key to conrm

CONFIGURING AUTOMATIC OPERATION
This conguration allows the control panel to monitor all the system operating parameters and display them together with
any alarm messages.
• Open the menu
SELECT
AUTOMATIC
• Press the
key to conrm the choice
• The
symbol will appear on the control panel display
• Press the ON/OFF
key to start the system.
• The pump running symbol will appear on the control panel display:
and/or
• The chosen operating mode (1 to 6) will appear on the lower alphanumeric display.
The control panel will always start in automatic MODE 1 the rst time it is powered up

CONFIGURING MANUAL OPERATION
This conguration is only intended for qualied personnel who are familiar with system control issues and the specic
characteristics of the control panel.
In manual operating mode, the pumps can only be activated by holding the ON/OFF key down. The
pump is deactivated as soon as the key is released.