Pelican TC Series - Configurations; Thermostat Settings

Identification
Allows for custom identifiers and notes for the
thermostat, the zone boxes being controlled, and any
other relevant information about the system.
Configuration Name/Description
Name – Allows for a unique name
to be assigned to the thermostat.
Normally this would be the room’s
name or number.
Examples: Room 101, Office 200,
Classroom 24B.
(no name) (D)
(empty) (D)Description – Allows notes to be
inputted for tracking information
unique to this thermostat and/or
the system this thermostat is wired
to.
The first line of this entry shows as
small text under the thermostat’s
name on the main control page.
Normally the first line would be the
zone box’s identification number.
Examples: Zone 01, VAV-01, TB-02,
VVT-05
Thermostat Settings
Set the thermostat as a zone damper controller.
Configuration Name/Description
System Type – Set to Zone Damper
since this thermostat will use the
zone damper sequence of
operations.
Zone Controller – Select the zone
coordinator which this thermostat
gets central air from.
Heat Zone Controller (advanced) –
Select the zone coordinator which
this thermostat gets central heat
from.
Conventional
Heat Pump
Zone Damper
¹
Dual Duct Damper²
(D)
(A)
(blank)
All installed zone
coordinators will
appear as selectable
options.
(D)
(blank)
All installed zone
coordinators will
appear as selectable
options.
(D)
¹Thermostats can only be configured as Zone Damper if there is a
zone coordinator installed and connected to the Pelican wireless
network.
²Dual Duct Damper will only show as a configuration if released by
Pelican Techinical Support. Contact Pelican support at 888.512.0490
or email support@pelicanwireless.com for further assistance.
³This selection only applies if you have a dual duct mechanical
system. Reference “Planning - Different Mechanical Systems - Dual
Duct (DD-VAV)” on page 12 for mor information.
Configurations
Thermostat and accessory configurations are set
through the Pelican Connect app. For the thermostats
to be configured, they must be connected to the Pelican
wireless network and the network must have an active
Pelican gateway.
Configurations must match the sequences for the
equipment the controllers are wired to. Reviewing each
configuration is crucial for proper sequencing. Incorrect
configurations can negatively impact the performance
of the equipment.
The controllers will not properly operate the equipment
if the following conditions are true:
◦ The thermostat and accessories are not correctly
wired to the equipment they are controlling.
◦ Temperature sensors are not installed correctly,
are not properly wired to the thermostat, or are
detecting inaccurate temperatures.
◦ A zone coordinator is not installed and therefore
the thermostats cannot be configured as zone
damper controllers.
◦ The thermostats have not been linked to or are
unable to communicate with their zone
coordinator over the wireless network.
◦ There are equipment malfunctions or other
mechanical issues that need to be fixed.
IMPORTANT
This section is for reference only. Pelican
thermostats and accessories recieve regular
updates and additional configuration options
that may not be included in this guide. For
further assistance or help with specific
application needs, contact Pelican engineering
support.
Navigating to the Configurations:
1. Login to the Pelican Connect app.
2. Select Admin.
3. Select Thermostat Configurations.
4. Select the thermostat being configured.
Table Key:
(D) = Default.
(R) = Range.
(advanced) = Advanced configurations are
provided but with limited access.
Settings/Range
Settings/Range
35