EasyManua.ls Logo

Pelpro PP60 - Page 13

Pelpro PP60
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.pelprostoves.com 7083-171H • February 23, 2015 13
2. Cleaning Firepot with the Firepot Clean-Out Tool;
• Frequency: Daily or more often as needed
• By: Homeowner
3. Ash Removal from Firebox
• Frequency: Weekly or more frequently depending on
ash build-up.
• By: Homeowner
a. The appliance must be in complete shutdown and cool
and the exhaust blower off. If you are just cleaning the
repot, there is no need to unplug the appliance.
b. Open the front door of the appliance and lift out the
firepot. Use the firepot cleaning tool to break up
deposits inside the repot and dispose in an approved
container. Depending on the quality of fuel used, the
front of the repot may need to be removed for better
access for cleaning.
c. Use the narrow end of the repot cleaning tool to clean
the holes.
d. With the repot out clean the area below the repot.
e. Reassemble the repot and place back inside the repot
riser. Make sure the repot is in the correct direction
with the slanted lip in the rear. Failure to install the
repot correctly may result in missed ignitions.
a. There must not be any hot ashes in the rebox during
cleaning so allow the appliance to completely cool. The
rebox ash should be removed every time the exhaust
path is cleaned. Frequent cleaning of the ash in the
rebox will help slow down the build-up of ash in the
exhaust blower and vent system.
b. Vacuum out the rebox thoroughly on both sides of the
rebox and the oor and ceiling. Remember to place
the ash and debris into a metal or non-combustible
container.
See Disposal of Ashes.
Disposal of Ashes
WARNING
Ashes should be placed in metal container
with tight tting lid.
Ashes should be retained in closed container
until all cinders have thoroughly cooled.
4. Disposal of Ashes
• Frequency: As needed
• By: Homeowner
Ashes should be placed in a metal container with a
tight- tting lid. The closed container of ashes should
be placed on a non-combustible oor or on the ground,
well away from all combustible materials, pending nal
disposal.
If the ashes are disposed of by burial in soil or otherwise
locally dispersed, they should be retained in the
closed container until all cinders have been thoroughly
cooled.

Table of Contents

Other manuals for Pelpro PP60

Related product manuals