www.pelprostoves.com 7083-171H • February 23, 2015 5
A. Appliance Certifi cation
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please contact
Pelpro for replacement glass.
B. Mobile Home Approved
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-04, ULC S627-00, (UM) 84-HUD
*BTU input will vary, depending on the brand of fuel you use
in your stove.**Heating capacity depends on climate zone,
structure layout, insulation, windows, etc.
MODEL: PP60
EPA Certifi ed:
0.277 grams per hour
Effi ciency:
85%
*BTU Input: 11,000 - 35,000 / hr
**Heating Capacity: 750 to 1450 sq. ft. depending
on climate zone
Vent Size: 3” or 4” L or PL
Hopper Capacity:
(Approx)
60 lbs
Fuel: Wood Pellets
Shipping Weight: 205 lbs
Series: PP60
Laboratory: Intertek
Report No. 10072262PRT-001
Type: Solid Fuel Room Heater/Pellet
Fuel Burning Type
Standard: ASTM E1509-04 and ULC S627-
00, Room Heater Pellet Fuel
Burning type and (UM) 84-HUD,
Mobile Home Approved.
These heaters meet the US Environmental Protection
Agency’s Emission limits for pellet heaters. Under specifi c
conditions the PP60 stove has shown to deliver heat at rates
ranging from 11,000 to 35,000 BTU/hr.
• This appliance is approved for mobile home
installations when not installed in a sleeping room and
when an outside combustion air inlet is provided.
• The structural integrity of the mobile home fl oor,
ceiling, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
use only listed double-wall connector pipe.
• Outside Air Kit provided with each unit must be
installed in a mobile home installation.
PP60 Series: 115 VAC, 60 Hz, Start 2.6 Amps,
Run 0.9 Amps
C. Glass Specifi cations
D. Electrical Rating (On High)
E. BTU & Effi ciency Specifi cations
WARNING
Fire Risk
Pelpro disclaims any responsibility for, and the
warranty and agency listing will be voided by the
below actions.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by the
manufacturer.
• Operate the appliance without fully assembling
all components
• Over fi re
• Install any component not approved by the
manufacturer
• Install parts or components not Listed or
approved
• Disable safety switches
Improper installation, adjustment, alteration, service
or maintenance can cause injury or property damage.
For assistance or additional information, consult a
qualifi ed installer, service agency or your dealer.
1 Listing and Code Approvals
To Next Page
Loading...
