Pelpro PP60 - Quick Start Guide

7083-171H • February 23, 2015 www.pelprostoves.com2
Q
UI
C
K
S
TART
G
UIDE
4.
Check all three baffl es are hooked
into slots.
*Before you plug in this appliance, follow these instructions*
3.
Verfi y fi repot’s orientation is
correct.
5.
Plug power cord into wall
receptacle.
Wait one minute.
*Green light will start fl ashing one time
per second*
7.
If the stove does not ignite follow
directions below. The LED light
should blink red four times showing
a missed ignition.
Turn the stove to off, remove and
EMPTY the fi repot.
CAUTION
Overfi lling the fi repot could cause an
unsafe ignition resulting in injury or
damage. Firepot must be emptied.
Return the fi repot to the stove
correctly (step 3) and then repeat
step 6.
8.
Once a fi re has been established
in the stove, leave the stove
burning on HI for 30 minutes to
allow paint to cure.
NOTE: Odors, vapors, and
smoke are released during initial
operation. Open windows or doors
for air circulation until burn off is
complete.
9.
After 30 minutes have passed, turn the dial control to OFF and then allow unit
to cool completely. Once cooled, open the door and clean the fi repot according
to the cleaning instructions found on the inside of the hopper lid, in the owners
manual, or on PelProStoves.com.
*Unit is now ready to resume normal operation*
6.
To prime the feed tube, QUICKLY
turn the dial control from OFF to HI,
back to OFF, then back to HI. The
feed motor will run continuously for
2 minutes and the LED light will be
solid green.
Once primed, pellets will drop
into the fi repot and the LED light
will blink green as the ignition
sequence starts.
Important: Allow up to 20 minutes
for ignition to take place.
CAUTION
Do not restart, manually add pellets,
or use any type of accelerant during
this process.
NOTE: Priming is only required
the fi rst time the appliance is lit,
or after the hopper has run
completely out of pellets.
1.
Turn Dial Control to OFF.
All material needs to be removed
from the door glass and fi rebox
before operation.
Follow all instructions and warn-
ings for safe start up of stove.
Failure to follow instructions
could result in injury or damage.
2.
Add pellets to hopper and close lid.
Back
Hole for Igniter
V
EL
Front
of
fi repot
has
the lip
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI
O
N
A
U
T
O
A
L
A
R
M
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI
O
N
A
U
T
O
A
L
A
R
M
2
1
4
3
5
6
7
8
9
10
LO
OFF
HI