12
7.5 Cable connection
As shown in the illustration, insert the plug of the wheel
speed sensor and electronic bottom bracket into the motor
in the two fittings.
Until model year 2021
It is not important to know which plug must be used for ei-
ther of the sensors, the motor automatically recognizes each
sensor.
From model year 2022
The electronic bottom bracket and the slot on the motor
have a 5-pin connector. The speed sensor is still 3-pin. This
shows where the electronic bottom bracket and speed sen-
sor must be plugged in.
Using the supplied M4x10 Torx-screws, attach the
connector cover to the battery holder from below
and tighten to a torque of 2.4 Nm +/- 0.2 N.
Tighten the chain wheel screws to a torque of 9
Nm +/- 2 Nm.
The chain wheels and pedals are not delivered
with the Pendix system. In other words, you can
use these parts of your bicycle if their dimensions
agree with the details given in the chapter 5.2
„Requirements for installation“.
Attach the right-hand crank with assembled
chain wheels and with applied chain on the
greased square sha section. Tighten the crank
using the supplied crank screw to a torque of 32
Nm +/- 2 Nm. The screw thread should already
have a thread locking for safety. If no locking is
on the thread, use a standard liquid screw lock-
ing (medium-strength). Caution: check this crank
for correct positioning opposite the crank on the
other side.
According to length and accessibility, you can lay out the
cable along or beside the frame tube. If necessary, fix it with
cable ties. When laying out and attaching the cable, make
sure it does not come into contact with the motor, the ped-
als and rotating parts!
The cable may otherwise be damaged. If the bicycle is a full
suspension bike make sure that the cable is not crushed or
abraded during suspension motion!
Speed sensor (3-pin)
Electronic bottom
bracket (5-pin)
Fig. From model year 2022
7.6 Pendix crank
You must attach the chain wheels before attaching the crank
to the bicycle.
To Next Page
Loading...
