20
15. EC Declaration of Incorporation
In accordance with EU Machine Directive 2006/42/EC dated 17 May 2006, Annexe II B
We herewith declare that the partly completed machine described below, in its design and structure as well as in the form made
commercially available by us, agrees with the following fundamental safety and health requirements to Annex I of Directive
2006/42/EC of the European Parliament.
Nos. 1.1.3.; 1.2.1.; 1.2.2.; 1.2.3.; 1.2.6.; 1.3.4.; 1.3.9.; 1.5.1; 1.5.2.; 1.5.4.; 1.5.5.; 1.5.6.; 1.5.8; 1.5.10.; 1.5.11.
Putting into operation (commissioning) is not allowed until and when – insofar as applicable - the machine into which the in-
complete machine or machine part is to be installed, fully agrees with the regulations laid down in Machine Directive 2006/42/
EU.
The technical documentation in accordance with Annexe VII part B have been provided, and will be transmitted to the relevant
(electronic) references in the separate states upon justified request to do so.
Manufacturer:
Pendix GmbH
Innere Schneeberger Straße 20
08056 Zwickau
Description and identification of the machine:
Function: Electric bicycle support motor (up to 25 km/ h or 15 ½ mph)
Type/model: Pendix eDrive
Serial number:
Construction year:
We herewith agree conformity with other guidelines/directives also applying to the product:
• RED Directive on the making available on the market of radio equipment (2014/53/EU), includes compliance with the EMC
Directive (2014/30/EU) as well as the Low Voltage Directive (2014/35/EU),
• RoHS II Directive (2011/65/EU)
Other guidelines followed:
• Directive on batteries and accumulators 2006/66/EC
• WEEE - Directive 2012/19/EU
Applied harmonized standards (norms) and technical
specifications followed:
• according to MD: DIN EN ISO 12100 | DIN EN ISO 13849-1 |
DIN EN 15194 | DIN 4210:2014
• according to RED: EN 300 328 V1.8.1 (4.3.1.1, 4.3.1.7,
4.3.1.8, 4.3.1.9, 4.3.1.10) | 301 489-1 | 301 489-17
• according to EMC: EN55014-1:2017 | EN 55014-2:2015 | EN
61000-3-2:2019 | EN 61000-3-3:2013
• according to LVD: EN 60335-1:2012+A11+A13 |
EN 60335-2-29:2004+A2
Authorized representative for technical
documentation:
Christian Hennig
(see Manufacturer’s address)
Place / date:
Zwickau, the 18th of November 2021
legally responsible person, details:
Christian Hennig, Chief Technical Oicer (CTO)
by the drive supplier
To Next Page
Loading...
