10
EasyTouch Control System User’s Guide
Switch on lights manually and synchronize light colors
From the Lights screen you can manually switch all lights on or off, and synchronize colored lights. Up to 12
lights can be controlled. For more information about setting up lights, including IntelliBrite
®
LED lights and
MagicStream
®
laminars, refer to “Lights Menu” on page 20.
To manually switch on all lights and synchronize light colors:
Press the Up/Down button to select All On or All Off. Use the Sync feature with
any combination of up to 12 SAm
®
, SAL
®
, IntelliBrite, FIBERworks
®
lights and
MagicStream laminars to synchronize their colors before switching the lights on.
Press the Menu button to save the settings and to return to the main menu items or
press the button again to return to the main screen.
Using the Once Only timer feature
The Schedules “Once Only” timer feature lets you to automatically switch equipment on for one time. This
feature allows you to program a circuit to turn on at a particular time on a onetime basis. For example, if you
wanted the spa to be heated when you arrive home, you could program the heater to switch on at a specific
time and after you have finished using the spa you can switch the heater off manually. After the program has
run, it is automatically erased. Unlike using the regular “Schedule” program, the “Once Only” program does
not repeat. The circuit must be turned off manually or wait for the 12 hour automatic shut-off. However, you
could also reset the 12 hour factory shut-off by entering an “Egg Timer” count down program to extend past
the default 12 hours shut-off.
To schedule a specific time to turn on the spa or pool heat using the “Once Only “ feature:
Right button: Select the Spa circuit.
Right button: Select Mode if there are existing programs. Skip this step to create a
new program.
Up/Down button: Select New to create a new program.
Right button: To create a new program and enter the “Mode” settings.
Up/Down button: 1/1 indicates that this circuit has one program. If there are existing
programs assigned to this circuit, use these buttons to view and select the existing
program settings.
Right button: To select the “Once Only” settings.
Right button: Move to start time settings.
Up/Down and Right buttons: Set the start hour (A/P) and minutes. A (AM) and
P (PM) time is set when setting the start hour.
Right button: Move to day of the week to run the program.
Right button: Select which day to run the program then press the Up/Down button
to enable the bar on top of the letter. A bar on top of the letter indicates the day
selected to run the program.
Press the Menu button to save the settings and to return to the Schedules menu
options. Press the Menu button again to return to the main menu options or press
again to return to the main screen.
Getting There
Menu Lights All On
▲
▲
MENU ▼ SCHEDULES SPA (POOL)
Getting There
▲
SPA 0/0
Mode: None (New)
S
SPA 0
POOL 0
AUX 1 0
AUX 2 0
T
S
X
SPA 1/1
Mode: Once Only
08:00A
SMTWTFS
T
S
_
Modes
Colors
All On
All Off
T
X
S
To Next Page
Loading...
Need help?
General
