Pentair EasyTouch 8 User Manual

53
EasyTouch Control System User’s Guide
Settings Menu: Set Password
If required, the password feature allows you to password protect the EasyTouch control panel. To access a
password protected control panel, you must enter the correct four digit password before access is granted.
Password
To enable the password protect feature:
Up/Down button: Select the password first digit (0-7) of the four digit password.
Right button: Select the next password digit. Repeat the previous step to enter each
of the password digits.
Right button: After you are finished entering the four password digits, press the
Right button to enable the password feature.
Up/Down button: Select Ye s enable the password feature.
Press the Menu button three times to save the settings and to return to the main
screen.
Note: If the password feature is enabled, the current four digit password can be
viewed from the EasyTouch outdoor control panel in the “Set Password” setting.
MENU ▼ SETTINGS ▼ SET PASSWORD
Getting There
T
Set Password
PW : [0000]
Enable : No
S
Settings Menu: Erase EEPROM (Erase System Memory)
EasyTouch system configuration data is stored and retained in “Flash” memory in an EEPROM located on the
control panel motherboard and optional Indoor Control Panel. The EasyTouch user system configuration data
can be erased to restore the factory defaults settings. System information automatically downloads from
programmed components to non-programmed components in case of accidental memory loss and to ease
board replacement. Any optional controllers (iS4, iS10, SpaCommand and QuickTouch QT4 controller) that
were configured need to be reconfigured.
Erase EEPROM
The following procedure describes how to erase the system memory from either the main EasyTouch control
panel or the EasyTouch Indoor Control Panel.
CAUTION: This procedure will erase all system settings. Any optional controllers will need to be
reconfigured.
Up/Down button: Select Ye s.
Right button: The message “Erase EEPROM Are You Sure? No” is displayed.
Up/Down button: Select Ye s.
Right button: Press this button to erase system data and restore the factory
defaults. The display will go blank, then the main screen will be displayed.
MENU ▼ SETTINGS ▼ Erase EEPROM Erase EEPROM
Getting There
▲
Erase EEPROM
Erase ALL? No (Yes)
T
S
T
S
Erase EEPROM
Are You Sure?
No (Yes)
AUTO HEATER
SPA 95°F / 100°F
AIR 70°F
MON 09:30 AM

Pentair EasyTouch 8 Specifications

General

Brand	Pentair
Model	EasyTouch 8
Category	Control Systems
Language	English