The screens will now take you through the provisioning process.
You are now ready to provision your valve.
1. From the XTRI control, press the gear button
on the
main screen to proceed to settings.
2. Turn the Bluetooth to “ON” and then click the check mark at
the bottom right hand corner.
3. A Bluetooth icon will appear in the upper right hand corner
of the main screen.
a. A black icon
reflects the Bluetooth is open,
but not connected.
b. A white icon reflects the Bluetooth signal is open
and connected.
c. The alert icon will show up on the screen until a
WiFi connection has been established.
4. Once the Bluetooth signal is open
on the screen, press
the continue button on the app to scan for the device.
Settings
FLECK 5800/5810/5812 XTR I Service Manual • 21
To Next Page
Loading...
