Setting: Start/Stop Cycle – Clock/Screen Contrast
Cycle Start and Stop Each Cycle has two screens, one for Start Cycle and one for Stop Cycle.
Press to access Start Cycle and set starting time. Press
again to access Stop Cycle and set stop time. Repeat this procedure for every
Cycle.
Press to scroll to Time/Contr.
You can program up to four start and stop cycles per day.
The more time the IntelliFlo
®
VF Variable Flow Pump is given to operate, the
less power and flow will be needed for turning over the pool.
Time and Contrast Setting Clock
Press to access Set Time.
Make sure to set AM/PM correctly.
The pump can store the correct time for up to 96 hours after power is shut
off. After 96 hours, the IntelliFlo
VF pump’s clock must be reset.
Adjusting Screen Contrast
Press to scroll to Contrast.
Screen contrast levels can be set from 0-9.
Avoid setting at 0 unless you are unable to read the screen due to bright sunlight.
13
IntelliFlo
®
VF Pump Quick-Start Guide
To Next Page
Loading...
Need help?
General
