Pentair IntelliFlo VF Quick Start Guide

The Modulated Output feature automatically increases pump flow to allow the
system heater to check the water temp and switch on if necessary. This feature also
allows flow control flexibility if filter cycle flow is less than needed for certain devices.
M.O. Flo also allows you to program flow intervals that can be used for water effects.
You will need to enable M.O. Flo, and set the flow rate, run times, and intervals
between run times. M.O. Flo will operate only during the “Filter Mode” time cycles.
Enabling M.O. Flo Press or to select M.O. Flo. Press to access M.O. Flo menu
settings.
Press and to enable. Press to save.
Setting M.O. Flo Press to access Set Flow setting. Press to access setting.
Flow Rate
Press and to select digit to modify. Change values by pressing and
When value is set, press to confirm value and save changes.
Setting M.O. Flo Press to access Set Run Time or Set Interval Time.
Run Time and
Interval Settings Press to access setting. Press and to select digit to modify.
Change values by pressing and .
When value is set, press to confirm value and save changes.
Enter
Enter
Enter
Modulated Output
(M.O. Flo)
IntelliFlo
®
VF Pump Quick-Start Guide
16

Pentair IntelliFlo VF Specifications

General

Brand	Pentair
Model	IntelliFlo VF
Category	Water Pump
Language	English