Features – Modulated Output and Backwash
17
Backwash The Backwash mode is initiated by pressing the Backwash button.
(The Backwash button doubles for rinse during operation.) A Rinse cycle is
automatically executed after the Backwash cycle. The IntelliFlo
®
VF Variable Flow
Pump will display a “Filter Warning” or “Service System Soon” message when the
filter needs to be cleaned. Before operating, you need to set the Backwash Flow
and Duration, and Rinse Duration.
Note: When using cartridge filters, the backwash cycle must be performed when
cleaning or replacing filters. When charging a D.E. system, charge the system first
during a normal running cycle. After the filter is charged, run backwash mode with
the filter valve in the filter position to reset the % clean filter status. Then run the
pump in filter mode.
Always perform Backwash before initial start-up and installation to ensure most
efficient system performance.
Setting Backwash Press and or to select Backwash menu.
Flow
Press to display Backwash Flow. Press to access setting.
Press and to select digit to modify. Change values by pressing and
When value is set, press to confirm value and save changes.
IntelliFlo
®
VF Pump Quick-Start Guide
Enter
To Next Page
Loading...
Need help?
General
