OPERATING THE PUMP 15/25
SET PROGRAMS 18 IN SCHEDULE MODE
In schedule mode, programs 1-8 can be programmed to run a certain speed or flow at a
certain time of day. To run a scheduled speed or flow, press start/stop. The screen will
display “Running schedules” when it is ready to run a scheduled speed or flow. If start/
stop is pressed while a scheduled speed or flow is running, the pump will stop running the
scheduled speed/flow. The pump will not continue to run the scheduled speed or flow until
the start/stop button is pressed again.
1. Press menu.
2. Use up or down arrows to scroll to “Program 1-8”, then press select.
3. Use up or down arrows and press select for the speed you wish to set and schedule.
4. “Operation mode” will display. Press select and use the up or down arrows to scroll to
“Schedule”. Press save.
5. Use the up or down arrow to scroll to “Set Type”. Press select and use the up or down
arrow to choose between “Speed” or “Flow”. Press save.
6. Use the up or down arrow to scroll to “Set Speed/Flow”. Press select and use the up or
down arrow to adjust the speed or flow settings.
7. Press save to save the new speed or flow setting.
8. Press the down arrow again. “Start Time” will display. Press select - the cursor will
highlight the minute column.
9. Use the up or down arrow to change the time and the left or right arrow to move cursor
from minutes to hours.
10. Press save to save the new start time setting.
11. Press down arrow - “Stop Time” will display. Press select.
Repeat Steps 8-9 to set stop time.
12. Press save to save the new stop time setting.
13. Press start/stop.
The IntelliFlo® VSF Variable Speed and Flow Pump will prime and begin to run the
programmed schedule at the specified start time. When running in Schedule or Egg Timer
mode, the countdown time (T 00:01) showing the hours and minutes remaining is displayed.
Programming Schedule for Constant Run
Two programs cannot be programmed with the same start and stop times. To run a program
without stopping, set the Start time one minute after the stop time. Example: A single program
will run non-stop if programmed with a Start Time of 8:00 AM and a Stop time of 7:59 AM.
Note: The pump will not run the scheduled speeds or flows until the Start/Stop button is
pressed (LED on) to place the pump in Schedule mode.
26
To Next Page
Loading...
