Need help?Do you have a question about the Pentair MICROBRITE and is the answer not in the manual?
General| Type | LED Pool Light |
|---|---|
| Voltage | 12V |
| Lens Material | Polycarbonate |
| Housing Material | Polycarbonate |
| Mounting | Flush Mount |
| Color Options | Multiple (e.g., white, blue, green, etc.) |
| Warranty | 1-year limited warranty |
Details dangers of high voltage, shock, burns, and potential death from underwater pool lights.
Manual control of MicroBrite lights via a standard wall-mount switch and 12 VAC transformer.
Automatic control of MicroBrite lights using Pentair IntelliTouch® and EasyTouch® systems.
Guidelines for using transformers with multiple lights, including cable length limits.
Specifies total allowable light wattage and individual light wattages with a 300W transformer.
Describes light behavior upon powering on, including how saved states are displayed.
Details using switch cycles to activate specific color shows and fixed colors.
Describes default and saved brightness levels upon powering on the white light.
How to select 100%, 75%, or 50% brightness using switch cycles.
Instructions on capturing and recalling specific color effects using controller buttons.
Emphasizes compliance with NEC, local codes, and electrician requirements for installation.
Highlights adherence to Canadian Electrical Code (CE) and local ordinances for installation.
Lists compatible wall fittings for mounting the MicroBrite light in pool return fittings.
Step-by-step guide for installing the MicroBrite light in a wet conduit setup.
Instructions on twisting the light cord counter-clockwise before inserting into the fitting.
Describes turning the light clockwise to untwist the cord as it's installed.
How to use the dedicated tool for securely installing the light into the wall fitting.
Steps for verifying proper operation after the light has been installed.
States that the light is non-serviceable and the entire assembly must be replaced.
Warns about electrical hazards if the system is not code-compliant before replacement.
First step is to switch off the electrical switch or circuit breaker at the source.
Instructions for disconnecting wires and physically removing the old light assembly.
Connecting the new light's power cord to the fish tape for pulling through conduit.
Refers to previous pages (7-10) for the detailed light installation process.
Wiring the new light's conductors to the corresponding circuit wires in the junction box.
Reiterates electrical shock risk when working with high-voltage control system panels.
Steps for opening and preparing the EasyTouch/IntelliTouch load center.
Detailed steps for assigning circuit names and functions in the EasyTouch system.
How to control and select light shows using the EasyTouch control panel.
Process for naming the MicroBrite light circuit within the IntelliTouch system.
Navigating display screens to locate and assign auxiliary circuits for the lights.
Steps to assign a circuit name to the main display screen for easy access.
Assigning the circuit function as 'INTELLIBRITE' for proper light control.
Configuring the MicroBrite lights within the system's 'Lights' screen interface.
How to select and operate various color modes on the IntelliBrite system.
Basic checks for MicroBrite lights not functioning properly, ensuring 12 VAC power.
Resolving issues with IntelliBrite Controller LEDs flashing due to load or short.
Lists available product bundles including lights and transformers.
Lists available replacement parts such as adaptor, tool, and O-Ring.
To Next Page
