Posi-Chlor® Salt Water Chlorinator Owner’s Manual
4
1.2.1 Common features in all Posi-Chlor® equipment
• Adjustment of chlorine production by switched mode power supply
• Power supply performance >90%
• Automatic switch-off owing to lack of water flow.
• Automatic switch-off owing to the accumulation of gas in the cell, with automatic restart
once the water flow is restored.
• Automatic voltage adjustment depending on the concentration of salt and the
temperature, keeping continuous chlorine production.
• Automatic cleaning cycle of electrodes.
• Automatic restart in the event of supply failure.
1.3 Recommendations and Safety Precautions
• The equipment should always be installed by qualified professionals.
• Disconnect the equipment from the mains before performing any
assembly or maintenance operation
• The Posi-Chlor® chlorinator must be connected to a GPO that is supplied through a
residual current device (RCD) having a rated residual operating current not exceeding
30 mA.
• It is important to ensure that the supply cables of the electrolysis cell
are tightly connected, otherwise the equipment could overheat and break down.
• Ensure that the heat-sink wings (in the rear part of the equipment) are not blocked and
that air can easily circulate through them.
• For optimum results, you should ensure the correct hydraulic operation of your
swimming pool equipment.
• Equipment housing has IP65 protection. However, it is highly recommended not to install
the equipment directly exposed to sunlight.
• Corrosive environments may reduce the lifespan of the equipment. Do not leave open
containers with acids or other chemicals near the equipment.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
1. GENERAL DESCRIPTION
To Next Page
Loading...
