SolarTouch
®
Solar Control System Installation and User’s Guide
SolarTouch
®
Solar Control System Installation and User’s Guide
Mounting the SunTouch
®
Controller
The SolarTouch Controller can be mounted on a flat vertical surface, such as a wall or
post.
Note: Select a convenient location to mount the SolarTouch controller and
be sure the location is greater than five (5) feet from the pool or spa and no
further than 15 feet from the pool/spa valve.
To mount the SolarTouch Controller Enclosure:
1. Position the enclosure against the vertical flat surface. If wall anchors
are being used, support the enclosure in position (horizontally level and
square) against the surface and mark the bracket hole pattern on the wall.
2. Secure the enclosure with three (3) screws in the mounting bracket holes.
If using wall anchors, use 3/16” drill and set the anchors and secure the
enclosure with screws.
Top mounting bracket
Lower Mounting bracket
14
AC1
AC4
AC3
AC2
PUMP
PUMP
FILTER/
BOOSTER
CLEANER
INTERRUPT
NEUTRAL
HOT
GROUND
ACTUATOR VA LVE
POOL SOLAR
SENSORS
RS485
BLK GRN YEL RED
1 A5 FUSE
To Next Page
Loading...
