Pentair SOLARTOUCH 521592 - Using the Solartouch Controller Control Buttons; Solartouch Controller Main Status Screens

SolarTouch
®
Solar Control System Installation and User’s Guide
SolarTouch
®
Solar Control System Installation and User’s Guide
Using the SolarTouch
®
Controller Control Buttons
Press Menu button
Enable/Disable
Enable
/ Disable
Target Temp
Water 60F
Target Temp 81F
Main Menu
Heating Menu
Enable/Disable
Target Temp
Main Menu
Cooling Menu
Press
UP/DOWN
button
Water 60F
Solar 50F
Enter
Enter
Enable
/ Disable
Enter
Enter
Enter
Enter
Press
Enter
button
Enter
Ente
r
Enter
Enter
40F
to
104F
40F
to
104F
3
SolarTouch Controller Main Status Screens
In normal operating mode the main screen displays the current WATER temperature,
TARGET Temperature and if SOLAR HEAT, NOCTURNAL COOLING or FREEZE is ON
or OFF. Press the Enter button to view the current Water and Solar temperatures.
Example: The following screens show SolarTouch controller in normal operating mode. The
water temperature is 60° F (15.6° C), solar heating is on and the target temperature is
80° F (26.7° C) (see Heating Menu page 5).
Press the Enter button to view
current solar temperatures.
Example: The following screens show SolarTouch controller solar is off. The water
temperature is 80° F, solar heating is off and the target temperature is 80° F (see
Heating Menu
Water 80F
Solar 90F
Using the Enter Button to Disable/Enable SolarTouch Controller
For service purposes, the SolarTouch Controller can disable Heating or Cooling. Press
and hold the Enter button for 3 secs. to disable the system. The display shows
“SolarTouch Disabled”. Press and hold the Enter button for 3 secs. again to enable the
SolarTouch controller. In the event of a power outage, after power is restored to
the SolarTouch controller the previous user settings are restored. Non-volatile memory
stores all user system settings.
Water 60F
Solar Heat On
Water 60F
Target Temp 80F

Water 80F
Solar Heat Off
Water 80F
Target Temp 80F

Main Menu