8
English
More and Less Output Buons
The More and Less buons control the percentage of me of each hour that the SC-75 Salt Chlorinator is producing chlorine
while the pump is on (see Sanizer Output LED indicators above). The lights act as a bar graph: the more lights that are on,
the more chlorine is produced. Flip the panel cover up to access the More, Less and Boost On/O buons. To exit Boost
mode, press and hold both the buons.
More: Increases the me the cell produces chlorine.
Less: Decreases the me the cell produces chlorine.
Boost On/O: Press and hold both the More and Less buons together to acvate Boost mode on or o. Boost mode sets the
sanizer output to run 100% for the next 24 hours of pool pump run me. If the me clock switches o the pump cycle, then
switches power back on the next day, Boost mode will connue unl 24 hours has elapsed since Boost mode was turned on
or Boost mode is canceled by the user. The Sanizer Output display will show a paern LED display to indicate Boost mode.
Self-Cleaning
The self-cleaning feature reduces scale buildup on the blades of the SC-75. The self-cleaning cycle tends to reduce the life
of the SC-75, therefore, it should be used only to the extent necessary to minimize the scale buildup on the blades. The self-
cleaning cycle can be adjusted to run every 3, 4, or 5 hours, whichever is the opmal for your parcular pool condions in
order to minimize scale buildup but maximize the life of the SC-75. It is factory set to two (2) hours for the rst 30 days of
operaon, then automacally switches to three (3) hours. To change the self-cleaning cycle, press and hold the LESS buon
for three (3) seconds. The sanizer output display will show the number of hours in a bar graph style. The number of output
LEDs lit is the number of reverse hours. Pressing More or Less buon will change this seng.
To Next Page
Loading...
Need help?
General
