61
Basic Operations
3
You can change the flash output in a range of -2.0 to +1.0. The following
flash compensation values can be set according to the step interval set in
[1. EV Steps] (p.72) of the [A Custom Setting 1] menu.
1
Press the four-way controller (3) in Step 2 on p.60.
2
Turn the e-dial.
The flash compensation value is set.
Press the d (G) button to reset the value
to 0.0.
Compensating Flash Output
EV Steps Selectable Flash Compensation Value
1/3 EV
-2.0, -1.7, -1.3, -1.0, -0.7, -0.3, 0.0, +0.3, +0.7, +1.0
1/2 EV
-2.0, -1.5, -1.0, -0.5, 0.0, +0.5, +1.0
• When the flash output exceeds its maximum amount, the compensation will
not be effective even if the compensation value is set to the plus (+) side.
• Compensating to the minus (-) side may have no effect if the subject is too
close, the aperture is set to a large opening, or the set sensitivity is high.
• The flash output compensation is also effective for external flash units which
support P-TTL auto flash mode.
Cancel
MENU
Auto Flash Discharge
OK
OK
+0.7
To Next Page
Loading...
