Pentax MZ-S Service Manual

27640 -12/34-
2
22
2-
--
-4. Eyepiece lens portion
4. Eyepiece lens portion4. Eyepiece lens portion
4. Eyepiece lens portion･･･Remove M311(adhered with Self adhesive tape)
2
22
2-
--
-5
55
5.
. .
. Set 0
Set 0Set 0
Set 0-
--
-A101 at Mirror
A101 at MirrorA101 at Mirror
A101 at Mirror-
--
-up condition.
up condition.up condition.
up condition.･･･Apply DC3V to
the mirror motor (Red +) and set Diaphragm coupler lever
swings up at the most top portion.
2
22
2-
--
-6
66
6. Bottom portion
. Bottom portion. Bottom portion
. Bottom portion･･･3 screws on 0-D11,
TY-CNL-D 1.7X4, D14(Shoulder screw).
2
22
2-
--
-7.
7. 7.
7. Rear
RearRear
Rear side
side side
side･･･2x TY-CNM 2.0X6.5, 1 screw(A190)
2
22
2-
--
-8. While setting free 0
8. While setting free 08. While setting free 0
8. While setting free 0-
--
-T100 from main body,
T100 from main body, T100 from main body,
T100 from main body,
lift Front cover block(Mirror box) and pull out
lift Front cover block(Mirror box) and pull out lift Front cover block(Mirror box) and pull out
lift Front cover block(Mirror box) and pull out
slowly.
slowly.slowly.
slowly.
[Sequence of Assembly]
[Sequence of Assembly][Sequence of Assembly]
[Sequence of Assembly]
2
22
2-
--
-1.Main body and 0
1.Main body and 01.Main body and 0
1.Main body and 0-
--
-A101(Front cover block).
A101(Front cover block).A101(Front cover block).
A101(Front cover block).
1） Make sure that 3 Washers W14 (t=0.05~0.07) on Main body and 1 on 0-A101
are adhered.
2） Set 0-A101 at Mirror up condition.
(Shutter charge lever should move down
and the hole on the gear should be visible
through the square hole. )
3） Arrange lead wires Flexi., and install to the Main body, Be careful not to pinch them.
4） Push towards the side of Back cover key and tighten screws in numerical order ①,②,③,④.
(A190:size 2X7.5)
5）0-D11･･･Tighten 4 screws in the order of ①,②,③.
2
22
2-
--
-2.[Chec
2.[Chec2.[Chec
2.[Check] Mechanical back
k] Mechanical backk] Mechanical back
k] Mechanical back
Tolerance
ToleranceTolerance
Tolerance：
：：
： 45.46
45.4645.46
45.46±
±±
±0.02 mm
0.02 mm0.02 mm
0.02 mm
0-S300
(0-A101)
①
②
③
④
③
①
②

Pentax MZ-S Specifications

General

Brand	Pentax
Model	MZ-S
Category	Digital Camera
Language	English