105
3
Taking Pictures
2
Use the four-way controller
(45) to select j or c and
press the 4 button.
The camera is ready for continuous
shooting and burst shooting.
3
Press the shutter release button halfway.
The focus frame on the display turns green when the camera focuses
on the subject at the correct distance.
4
Press the shutter release button fully.
Pictures are taken continuously as long as you keep the shutter release
button pressed.
• The flash does not discharge in j and c modes.
• j and c cannot be selected in 9 (Green), b (Auto Picture),
(Digital Microscope), A (Night Scene), C (Movie),
(Underwater Movie), S (Fireworks), N (Frame Composite),
X (Digital Wide) or F (Digital Panorama) modes.
• Digital Zoom and Intelligent Zoom are unavailable when the sensitivity
is set to 3200 and higher.
• Digital Zoom and Intelligent Zoom are not available in c mode.
•With j, you can continue shooting until the memory capacity of the
SD Memory Card or built-in memory is full.
• The interval of j varies according to the [Recorded Pixels] and
[Quality Level] settings.
• The focus, exposure and white balance are locked with the first shot.
• When the Face Detection function is activated (p.81), it works only
when taking the first shot.
• The Blink Detection function works only for the last shot.
• The number of recorded pixels is fixed at f/W in j and c
modes. When the shooting mode is set to (Report), the number of
recorded pixels is set to V (1280×960).
MENU
Cancel
MENU
Cancel
OK
OK
OK
OK
Drive Mode
Drive Mode
Continuous Shooting
Continuous Shooting
To Next Page
Loading...
