Pentax Optio W90 - Names of Operating Parts; Monitor Indications

24
The display changes in the following sequence each time you press the
4/W button: “Normal Display”, “Histogram + Info”, “No Info”,
“LCD Off”, “Simple Display + Subscreen”.
Names of Operating Parts
Refer to “Understanding the Button Functions” (p.60 - 63) for an
explanation of the function of each button.
Monitor Indications
Display in A Mode
• All the camera buttons function as normal even when the LCD is off.
Press the shutter release button to take pictures as normal.
• Y appears if you press the shutter release button halfway when
camera shake is likely to occur. To prevent the camera from shaking,
use a tripod, a remote controller (optional) and/or the self-timer
function (p.103, p.106).
• You cannot turn off the LCD or change the information on the display
to “Simple Display + Subscreen” in N (Frame Composite) and
F (Digital Panorama) modes.
• You cannot change the information on the display by pressing the 4/
W button in 9 (Green) mode or X (Digital Wide) mode.
• In (Digital Microscope) mode, the 4/W button only
switches between the Normal display and the No Info display.
4/W button
3 button
Four-way controller
Green/i button
Power switch
I button
Q button
w/x/f/y button
Shutter release button