Pentax Optio W90 - Using the Power Saving Function

251
7
Settings
You can save battery power by setting the display to dim automatically
when no operation is performed for a fixed time. After the power saving
function has been activated, the display returns to the ordinary
brightness if any button is pressed.
1 Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2 Use the four-way controller (23) to select [Power
Saving].
3 Press the four-way controller (5).
A pull-down menu appears.
4 Use the four-way controller
(23) to select the time until
the camera enters power
saving mode.
Choose from [2min.], [1min.], [30sec.],
[15sec.], [5sec.] or [Off].
5 Press the 4 button.
The setting is saved.
Using the Power Saving Function
• Power Saving does not function in the following situations:
- While taking pictures in the continuous shooting mode
- In the playback mode
- During movie recording
- While the camera is connected to a computer
- When using the AC adapter
- While a menu is being displayed
- In the (Digital Microscope) mode
• When no operation is performed after the camera is turned on, Power
Saving is activated only after 15 seconds elapse even if [5sec.] is set.
3/4
MENU
Off
5
15
30
1
2
Setting
Quick Zoom
Guide Display
Reset
Delete All
sec.
sec.
sec.
Auto Power Off
min.
min.
Power Saving
OK
OKCancel